Siemens CA 343 Series Manual do Utilizador descarregar pdf (Página 3)

In the General tab, click on Properties; this opens a popup window where you can set up the Ethernet network.

Do as follows (Figure 3):

1. Setup the IP address for the PLC, here 192.168.200.20.

2. Click new to create a new Ethernet network.

3. Click OK.

Figure 3

4. Make sure the Ethernet network just created is selected. This identifies the Network the CPU will

be connected to and activate the Ethernet port (Figure 4).

Figure 4

Then click OK to close all popup windows and return to HW Config. Save the configuration and close HW

Config. The PLC configuration is done; you can now download in the PLC.

1 2 3 4 5 6 7 8 ... 17 18

Sem comentários

Siemens CA 343 Series Manual do Utilizador Página 3