Siemens IP-Module Especificações descarregar pdf (Página 15)

Siemens TCP/IP Ethernet Driver Help

Step 3: Assigning Module Address

1. Enter the IP Address, Subnet Mask and Gateway Address if applicable. Alternatively, enable BOOTP if

applicable.

2. Select Auto Detect Communications to allow the module to automatically select either 10BaseT or

100BaseT. In rare cases where there may be a cable issue that does not allow the module to operate properly at

100BaseT, force the module to use 10BaseT. This will increase the modules' tolerance to a bad Ethernet line.

3. The image shown below contains demonstration values.

Step 4: Number of Configured Connections

1. Enter the number of desired available connections for this device. If 0 is entered, the only connection available

will be the PG connection used by Micro/WIN.

www. kepware.com

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 84 85

Sem comentários

Siemens IP-Module Especificações Página 15