Siemens CCBS1337-MP Manual de Instruções descarregar pdf (Página 13)

Installing the

Camera

Siemens Building Technologies

Fire Safety & Security Products 03. 2005

7 Installing the Camera

7.1 Installation

Connect the BNC cable to the video output ⑥

Connect the power source to the power terminal

Caution:

If using a DC supply, make sure the polarity is correct. Incorrect connection may cause malfunction

and/or damage to the camera.

3. To reduce radiation sufficiently, please wind one turn around the core, see figure

below

Location Core illustration for what camera

Power cable

Y/C cable

LP / MP

EIM-0050751G

4. Adjust the back focus

The back focus is factory-adjusted before delivery for a CS mount lens. If re-

adjustment is necessary, please loosen screw

②

, set the camera to AES mode

(see section 7.2.14.2: BACK FOCUS), then rotate the back focus wheel ① until a

sharp image appears. Tighten screw ②.

7.2 Function Settings

Select ENTER on the OSD; the menu will appear on the display and will disappear

after 30 seconds if no action occurs. The shaded setting area means an item is

selected; it keeps blinking.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Sem comentários

Siemens CCBS1337-MP Manual de Instruções Página 13