Siemens DTU3005-B Manual do Operador descarregar pdf (Página 82)

Appendix E: Device Data Format

78 Siemens Energy & Automation, Inc.

Control Parameters 18 Bit Contents

7 Ground Fault Enable

6 Service Factor (0 = 1.0)

5Auto Reset Enable

4 Phase Unbalance Enable

3 Emergency Reset Enable

2 Jam Protection Enable

1 Loss of Load Enable

0 Reserved

Ambient Temperature 19 0...70 Degrees C

Reserved 20

–23 For Future Expansion

1. This register location represents the sequential registers and their numbers within the device itself; as illustrated in Figure 5.1 in Chapter 5, the data

Device Command Data Retrieved From PLC (SAMMS LV and MV)

First Command Word (Command Word) Second Command Word (Data or Value)

0 = No Command to Perform Unused for Command 0

1 = Change Timing Byte 1 New value for timing byte 1 (0

–

200 seconds)

2 = Change Timing Byte 2 New value for timing byte 2 (0

–

200 seconds)

3 = Force Pushbutton On Pushbutton to force on

1 = Stop/Off Button

2 = Start/On Button

3 = Left/Reverse Button

4 = Hand Button

5 = Off Button

6 = Auto Button

7 = Reserved for Later Use

8 = Reset after Trip

4 = Change Overload Trip Overload Trip Class (2–23)

5 = Change Ground Fault (0 = Warning, 1 = Protection Enabled)

6 = Change Phase Unbalance (0 = Protection Disabled, 1 = Enabled)

7 = Change Ambient Temperature Ambient Temperature (0–70)

Real-Time Device Data Stored in PLC (SAMMS LV and MV) (Continued)

Real-Time Data Register Location in

PLC Block

Range or Contents

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 140 141

Comentários a estes Manuais

Sem comentários

Siemens DTU3005-B Manual do Operador Página 82

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Siemens DTU3005-B